Prices are competitively priced to Japanese Domestic Market!

SPECIFICATIONS

■ RWD Gear Drive Drift Car
■ 2.4mm Thick Lightweight Graphite Chassis
■ Vertical Mount Graphite Upper Deck
■ Suspension Type Graphite Suspension Arm
■ 3-Gear/4-Gear Compatible Aluminum Rear Bulkhead
■ Differential Height Adjust
■ New Ultra-Lightweight Slide Rack steering system
■ Graphite rear ESC mount
■ Adjustable motor position
■ Front and rear aluminum shock towers
■ Big bore aluminum low friction shocks
■ Lightweight graphite battery holder

The front area has been designed with a focus on weight reduction by narrowing down the adjustment points to the minimum required while increasing rigidity and accuracy. By minimizing overhang weight, careless understeer is prevented.

Around the slide rack, which has achieved a significant weight reduction compared to the conventional model. The bulkhead and base are integrated into a thin slide rack that supports 3 bearings, which greatly contributes to weight reduction around the front.

The steering block and lower rod are the same parts as before .

The front and rear suspension arms are based on 5mm thick graphite. Compared to resin, it is resistant to temperature changes and can maintain its rigidity regardless of the season. In addition, the pivot position of the suspension arm and damper also has the effect of a gull arm, allowing the suspension to move smoothly and roll smoothly.

The battery is designed exclusively for short Li-po. It is mounted at the rear end of the chassis with a simple holder .

Adopts a vertical upper deck that can bring out the softness of the roll while increasing the pitching rigidity.

A graphite rear ESC mount is also standard equipment .

The suspension arm is suspended from the bulkhead, allowing the roll center to be lowered as much as possible. It is also possible to change the width of the vehicle, adjust the skid angle, and adjust the angle of the damper.

The aluminum high-precision rear bulkhead stands out for its lightness of drive. The standard is a 3-gear specification, but by adding an idler gear and changing its position, it can also be used as an anti-torque 4-gear transmission.

The differential can be accessed by simply removing the cap at the bottom of the rear bulkhead. It is designed to increase work efficiency even when replacing the gear differential or performing maintenance on the ball differential. of the differential by changing the aluminum adapter that holds the differential and adjusts the rear traction.

The rear body mount is a flat carbon plate and supports body post attachment and magnet mount.

What you need to run the assembly kit
: 2-channel radio set (transmitter, receiver, speed controller, servo), battery (Li-po 2 cell, square short size), charger, 1/10 size drift tires・
The kit does not include body, wheels, tires, motor, batteries, pinion gear, and other R/C electrics.

____

Instruction Manual